19 raring2go.co.uk Raring2go! MAKE 2 Raring2go! PLACES TO GO your pinky finger, pull each loop up and over individually, starting from the bottom, leaving one loop on each finger again. Leaving one loop. Give it a tighten by pulling on the wool. Step 3 : How to add a row to your finger knitted beanie hat DIY This time we only need to hook into one loop on the knitted piece. Find your next loop and hook your little finger into it.Then knit another row. Once again, on the little finger pull each loop off individually. Pull to tighten. Find your next loop and hook into it. Knit another row across. Keep knitting until the hat covers your head. Remember to keep trying on the hat for measurements. Step 4 : How to decrease Next stage is to make the top of your hat.We need to start decreasing.This time you need to pick up two loops from the knitted piece, so you have three loops on your little finger. Then start to knit another row. Keep repeating these steps until the top of your hat is almost closed. Leaving a small gap. Step 5: How to decrease and finish your beanie Start casting off your fingers. Pull the first loop off and onto your next finger. And pull the bottom loop up and over the top. Do this on all your fingers, until you have one left.Then pull the wool through the last loop. Get scissors and cut the loop.To close off the top I laced through each loop across the top keeping it nice and tight, closing the top off completely. Make sure you keep pulling tight.You then just need to tie a knot in the wool to finish. If you’d like to see a video , here’s the full tutorial here… https://www.youtube.com/watch?v=p4IoOa_S MUE Many thanks to RedTedArt for sharing this fabulous Beanie creative. If you’d like to see so much more on crafting, visit redtedart.com
RkJQdWJsaXNoZXIy NDA0NjA=